[asterisk-users] Linksys SPA3012 inbound FXO problems

[lenz]

Thanks a lot, that did the trick! Wish there was an half-decent manual on  
the site at least.... :-(
l.


In data Thu, 03 May 2007 18:34:34 +0200, Dave Cotton  
<dcotton at linuxautrement.com> ha scritto:

> On Thu, 2007-05-03 at 17:56 +0200, lenz wrote:
>> Hello list,
>> hope someone can help me - I'm going crazy using the FXO port a SPA3012.
>> I would like the SPA 3012 to act as a simple FXO port to an Asterisk,  
>> that
>> is, once it detects a call, it should simply send it over to the local
>> Asterisk server. No intelligent routing, PIN, anything else....
>>
>> I configured it like this:
>>
>> PSTN-To-VoIP Gateway Setup
>> PSTN-To-VoIP Gateway Enable: yes
>> PSTN Caller Auth Method: none
>> PSTN Ring Thru Line 1: no
>> PSTN Caller Default DP: 1
>>
>> Then I configured the dialplan #1 as:
>> Dial Plan 1: (S0<:@gw1>)
>
> And that's where it started to go wrong.
>
> (S0<:s at asterisk.ip.address:5060>)
>
> will do what you want.
>
>



-- 
Home of QueueMetrics - http://queuemetrics.com