[asterisk-users] Linksys SPA3012 inbound FXO problems

[Drew Gibson]

http://www.sipura.com/support/index.htm

lenz wrote:
>
> Thanks a lot, that did the trick! Wish there was an half-decent manual 
> on the site at least.... :-(
> l.
>
>
> In data Thu, 03 May 2007 18:34:34 +0200, Dave Cotton 
> <dcotton at linuxautrement.com> ha scritto:
>
>> On Thu, 2007-05-03 at 17:56 +0200, lenz wrote:
>>> Hello list,
>>> hope someone can help me - I'm going crazy using the FXO port a 
>>> SPA3012.
>>> I would like the SPA 3012 to act as a simple FXO port to an 
>>> Asterisk, that
>>> is, once it detects a call, it should simply send it over to the local
>>> Asterisk server. No intelligent routing, PIN, anything else....
>>>
>>> I configured it like this:
>>>
>>> PSTN-To-VoIP Gateway Setup
>>> PSTN-To-VoIP Gateway Enable: yes
>>> PSTN Caller Auth Method: none
>>> PSTN Ring Thru Line 1: no
>>> PSTN Caller Default DP: 1
>>>
>>> Then I configured the dialplan #1 as:
>>> Dial Plan 1: (S0<:@gw1>)
>>
>> And that's where it started to go wrong.
>>
>> (S0<:s at asterisk.ip.address:5060>)
>>
>> will do what you want.
>>
>>
>
>
>
> --Home of QueueMetrics - http://queuemetrics.com
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users

-- 
Drew Gibson

Systems Administrator
OANDA Corporation
416-593-6767 x322
www.oanda.com