[asterisk-users] Is logic right?

[Michael Sullivan]

OK.  My basic asterisk install seems to be working.  I can get caller
ID.  My dialplan says:

[incoming]
; incoming calls from the FXO port are directed to this context from
zapata.conf
exten => s/9185415897,1,Set(CALLERID(name)=Michael Sullivan)
exten => s/9185415897,1,HANGUP(1)
exten => s,1,Set(CALLERID(name)=Someone Else)

This is for testing.  It's supposed to check the caller ID to see who is
calling, and if it's my cell phone, hang up, but let any other number
through to ring on our handsets.  Instead it rewrites the caller ID name
to Michael Sullivan and allows the call to pass through.  Here is the
output of the call to the CLI:

    -- Starting simple switch on 'Zap/1-1'
    -- Executing Set("Zap/1-1", "CALLERID(name)=Michael Sullivan") in
new stack
  == Auto fallthrough, channel 'Zap/1-1' status is 'UNKNOWN'
    -- Hungup 'Zap/1-1'
    -- Starting simple switch on 'Zap/1-1'
Dec 19 16:51:37 NOTICE[7413]: chan_zap.c:6073 ss_thread: Got event 18
(Ring Begin)...
    -- Executing Set("Zap/1-1", "CALLERID(name)=Someone Else") in new
stack
  == Auto fallthrough, channel 'Zap/1-1' status is 'UNKNOWN'
    -- Hungup 'Zap/1-1'

In fact, the "hang up on my number" clause isn't even shown in the
dialplan in the CLI:

camille*CLI> show dialplan incoming
[ Context 'incoming' created by 'pbx_config' ]
  's' =>            1. Set(CALLERID(name)=Michael Sullivan)
[pbx_config]
  's' =>            1. Set(CALLERID(name)=Someone Else)
[pbx_config]
camille*CLI> 
-= 2 extensions (2 priorities) in 1 context. =-
camille*CLI> 


What am I doing wrong?