[Asterisk-Users] TDM400P Not loading Drivers

[Rich Adamson]

Inline...

> I am trying to get the drivers working with this device with 4 fxo 
> modules on it. I do a modprobe zaptel and no errors appear. But when I 
> do modprobe wctdm the following errors appear:
> 
> Notice: Configuration file is /etc/zaptel.conf
> line 4: Cannot get number of tones chanel 1
> line 4: Cannot init tones chanel 1
> line 4: Cannot get number of tones chanel 2
> line 4: Cannot init tones chanel 2
> line 4: Cannot get number of tones chanel 3
> line 4: Cannot init tones chanel 3
> line 4: Cannot get number of tones chanel 4
> line 4: Cannot init tones chanel 4
> 
> 8 error(s) detected
> 
> /lib/modules/2.4.22-2f/misc/wctdm.o: post-install wctdm failed
> /lib/modules/2.4.22-2f/misc/wctdm.o: insmod wctdm failed
> 
> 
> I have googled the mailing lists and have not been able to find 
> anything on these errors.
> 
> My config of zaptel.conf
> 
> fxsks=1-4
> loadzone=au
> defaultzone=au
> channels=1-4

Unless the above is a typo, "channels=1-4" should not be in this file;
only the first three lines
 
> zapata.conf
> 
> [channels]
> language=en
> 
> ; XTDM20B Port #1,2 plugged into PSTN
> ;
> context=from-1800
> signalling=fxs_ks
> faxdetect=incoming
> usecallerid=yes
> echocancel=yes
> echocancelwhenbridged=no
> group=1
> channel=1

Not sure about the syntax of "channel=1"; I know channel=>1 works though.

> context=from-pstn
> signalling=fxs_ks
> faxdetect=incoming
> usecallerid=yes
> echocancel=yes
> echocancelwhenbridged=no
> echotraining=800
> group=3
> channel=2-3
> 
> context=from-fax
> signalling=fxs_ks
> faxdetect=incoming
> usecallerid=yes
> echocancel=yes
> echocancelwhenbridged=no
> echotraining=800
> group=3
> channel=4