[Asterisk-Users] CAC ADIT600 / T400 config

[Steven Critchfield]

On Sat, 2003-05-31 at 20:34, TC wrote:
> Yea looks like i have a issue with t400 spans 2 & 4 :(
> I now can get 2 pretty green lights on span 1 and span 3 &
> on the adit 600 on T1-1 and T1-2 ..and the 2 fxs/3fxo card are all green
> So i plow'd ahead on possible shakey ground ...
> 
> But now i dont get any dial tone when i pick up a hand set, the adit 600
> recognizes the off hook & goes amber but * does not see it off hook
> And it has registered the channels
>   == Parsing '/etc/asterisk/zapata.conf': Found
>     -- Registered channel 1, FXO Kewlstart signalling
> 
> just curious what signaling did you need on the ports for * to be a happy
> camper
> with adit fxs cards
> 
> >>After mucking around with it a bit, I was able to get it to sync with the
> >>channel bank as the clock source for the line:
> >>jsci-cbank1> show clock
> >> Primary Master Transmit Clock Source:    Internal
> >>  Secondary Transmit Clock Source:         Slot A DS1 2
> So this means you  have the adit suppling timing to asterisk t1 spans
> so your zaptel looks like this
> span=1,0,0,esf,b8zs
> span=2,0,0,esf,b8zs
> span=3,0,0,esf,b8zs
> span=4,0,0,esf,b8zs
> fxoks=1-24

Have you connected all the FXS and FXO ports to the DS0 ports? 
-- 
Steven Critchfield <critch at basesys.com>