[Asterisk-Users] CAC ADIT600 / T400 config

[TC]

Yea looks like i have a issue with t400 spans 2 & 4 :(
I now can get 2 pretty green lights on span 1 and span 3 &
on the adit 600 on T1-1 and T1-2 ..and the 2 fxs/3fxo card are all green
So i plow'd ahead on possible shakey ground ...

But now i dont get any dial tone when i pick up a hand set, the adit 600
recognizes the off hook & goes amber but * does not see it off hook
And it has registered the channels
  == Parsing '/etc/asterisk/zapata.conf': Found
    -- Registered channel 1, FXO Kewlstart signalling

just curious what signaling did you need on the ports for * to be a happy
camper
with adit fxs cards

>>After mucking around with it a bit, I was able to get it to sync with the
>>channel bank as the clock source for the line:
>>jsci-cbank1> show clock
>> Primary Master Transmit Clock Source:    Internal
>>  Secondary Transmit Clock Source:         Slot A DS1 2
So this means you  have the adit suppling timing to asterisk t1 spans
so your zaptel looks like this
span=1,0,0,esf,b8zs
span=2,0,0,esf,b8zs
span=3,0,0,esf,b8zs
span=4,0,0,esf,b8zs
fxoks=1-24


Could post the output of
print config

from the adit 600 cli