[asterisk-users] Digium TE220 card partially detected

[Maxim Litnitskiy]

> lspci can detect the card: 03:08.0 Communication controller: Digium, Inc.
> > Device 0220 (rev 02)
> > dahdi_hardware also:
> > astpbx ~ # dahdi_hardware
> > pci:0000:03:08.0     wct4xxp+     d161:0220 Wildcard TE220 (4th Gen)
>
> Fine. The card is indeed handled by the module (+).
>
> > astpbx ~ #
> > But dahdi_tool does not show the card and dahdi_cfg gives
> DAHDI_SPANCONFIG
> > failed on span 1: Invalid argument (22)
>
> Next: are you sure that it is configured for E1 and not for T1? What is
> the output of:
>
>  cat /proc/dahdi/1
>
Please see what's there:

NET: Registered protocol family 10
lo: Disabled Privacy Extensions
eth0: no IPv6 routers present
ACPI: PCI Interrupt Link [APC6] enabled at IRQ 16
ACPI: PCI Interrupt 0000:03:08.0[A] -> Link [APC6] -> GSI 16 (level, low) ->
IRQ 16
Found TE2XXP at base address f5100000, remapped to f8d64000
TE2XXP version c01a016a, burst ON
Octasic optimized!
FALC version: 00000005, Board ID: 09
Reg 0: 0x2b817400
Reg 1: 0x2b817000
Reg 2: 0xffffffff
Reg 3: 0x00000000
Reg 4: 0x00000001
Reg 5: 0x00000000
Reg 6: 0xc01a016a
Reg 7: 0x90001300
Reg 8: 0x00000000
Reg 9: 0x00ff0000
Reg 10: 0x0000004a
Found a Wildcard: Wildcard TE220 (4th Gen)
astpbx dahdi # cat /proc/dahdi/1
Span 1: DAHDI_DUMMY/1 "DAHDI_DUMMY/1 (source: RTC) 1" (MASTER)

astpbx dahdi #
astpbx dahdi # ls /proc/dahdi/1
/proc/dahdi/1
astpbx dahdi #
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20090211/1c900ffa/attachment.htm