[asterisk-users] Dahdi_genconf does not generate NT/TE configuration

[Tzafrir Cohen]

On Fri, Dec 04, 2009 at 04:06:29PM +0100, Olivier wrote:
> 2009/12/4 Tzafrir Cohen <tzafrir.cohen at xorcom.com>
> 
> > On Fri, Dec 04, 2009 at 02:42:18PM +0100, Olivier wrote:
> > > Hi,
> > >
> > > I'm using revision 6822 of Dahdi Tools.
> > >
> > > # dahdi_hardware
> > > pci:0000:05:06.0     wcb4xxp+     d161:b410 Digium Wildcard B410P
> > >
> > > # asterisk -rx "dahdi show version"
> > > DAHDI Version: 2.2.0.2 Echo Canceller: OSLEC
> > >
> > > # cat /etc/dahdi/genconf_parameters
> > > ...
> > > pri_termtype
> > >         SPAN/1          TE
> > >         SPAN/2          TE
> > >         SPAN/3          NT
> > >         SPAN/4          NT
> >
> > With BRI cards dahdi_genconf assumes that it uses whatever the card is
> > jumpered for.
> >
> 
> OK but I'm quite certain I set each jumper this way :
> jumper 1 and 2 in TE mode, 3 and 4 in NT modes with termination).
> How can I further check jumpers are correctly "read" ?
> 
> As it worked correctly after I hand edited system.conf and
> dahdi-channels.cont with appropriate values and I connected port 1 to port 4
> (and port 2 to 3), I would say there might an issue in card jumper
> detection.

The qozap driver showed it in name of the driver (or was it the
description)?

Hmm... what about wcb4xxp?

-- 
               Tzafrir Cohen
icq#16849755              jabber:tzafrir.cohen at xorcom.com
+972-50-7952406           mailto:tzafrir.cohen at xorcom.com
http://www.xorcom.com  iax:guest at local.xorcom.com/tzafrir