[asterisk-users] Error Counters on PRI Circuit

[Don Pobanz]

> Joe Pukepail wrote: 
> 
> 	Is there a way to see error counts on the T1 of a PRI?  
> Hooked up to asterisk via a digium TE122.   Looking for 
> something to make sure I'm not getting any CRC, framing or 
> other errors on the T1. 
> 	

Many moons ago I use to used a program called zttool. It allowed looking
at spans and the alarm state and bipolar errors and bit errors etc. You
could also see which channels were in use and look at signaling bits. 

Anyhow this program sits in the zaptel directory. You may want to check
it out. 

Don Pobanz

--
MailDefender Message Security: Click below to verify authenticity
http://www.exchangedefender.com/verify.asp?id=m4LIME3X015989&from=dpobanz@hastingsutilities.com