[Asterisk-Users] IAXphone -> ip address -> extension number.

[Zoltan Szecsei]

Ha!
I think I found my phone - see point 2 on my previous post (copied below).
Although the sticker on the bottom of my phone does have "ALDU", the 
firmware version is 02.09.07

So, it should cope with IAX only (and no SIP at all), yet I cannot get 
it registered (yet)

http://voip-info.org/tiki-index.php?page=ACT+P104+IP+Phone

Sorry to add to my prev post/request.

regards,
Zoltan



Rich Adamson wrote:

> The iax2 show peers is indicating the phone is not registering
> properly. (If the phone "never" changes IP addresses ever, then he
> "could" put a host= statement in the iax.conf, but that is very
> non-standard and will only serve to confuse people.)
>  
>
In my reply to "time bandits" suggestion, that is exactly what I did and 
"iax2 show peers" now shows the IP address.

*but* I still cannot dial anywhere.

What you have insinuated in your comment is that Asterisk and the phone 
should have automatically sorted themselves out and because this is not 
happening, my problem is elsewhere - proven by the fact that I have 
hardcoded host=192.168.0.201 in the iax.conf file (whereas before I used 
to have host=dynamic) and it still does not work.

Possibilities:
1) The iax timing error when I load asterisk (see reply to time bandit)

2) The phone itself. They are 2 new Advantage Century Telecomms Corp 
AC-104ALDU units which I bought because they were both SIP and IAX 
compatible. No documentation came with them and on the web page I could 
only find SLD specs, not model ALDU specs. Hmmmmm - I wonder how good 
that IAX claim is.....

http://www.act-tel.com.tw/_UpLoad/Pic/P104S-Spec.pdf


Any suggestions how I should proceed?

TIA,
Zoltan