[Asterisk-Users] TE410P lights don't blink read after the module is loaded

Peter Svensson psvasterisk at psv.nu
Tue Nov 30 00:17:01 MST 2004


On Mon, 29 Nov 2004, Mark F. Vickers wrote:

> According to the FAQ "When you load the module and have no 
> circuit/channel bank the LED's should flash red"
> 
> I get the "knight rider" lights before the module loads, but after the 
> modules are loaded I don't get any lights, other equipment plugged in or 
> not.

Have you run ztcfg to load the zaptel.conf configuration into the driver?

Peter





More information about the asterisk-users mailing list