[Asterisk-Users] User problem
Clive Carter
clive.carter at sbcs.co.uk
Mon Nov 1 09:57:12 MST 2004
The user is me !
I decided to try out *, and installed the xorcom Rapid installation
With the help of the wiki and reading posts on this list, I have got to
the stage where I have got an internal pbx, and able to dial out
and receive calls.
I am know trying to incorporate one analog line into the system.
I have a x100P.
If I use the Rapid front end and look in zttools, the X100p is showing
as a RED alarm. Don't know if that has anything to do with my problem
ztcfg reports
Channel 01 : FXS Kewlstart (Default) (Slaves : 01)
1 Channel{s) configured.
Zaptel.conf
fxsks=1
(loadzone and default zone stuff)
Zapata.conf
signalling = fxs_ks
Channel => 1
If Channel=>1 is changed to ;Channel =>1, Asterisk loads ok
However, when Channel =>1 is enabled, asterisk won't start
Gives following errors
ERROR[16384]: chan_zap.c: 6181 mkintf : Unable to get parameters
ERROR[16384]: chan_zap.c :9109 setup_zap : Unable to register channel '1'
WARNING[16384] : loader.c:334 ast_load_resource : Chan_zap.so :
load_module failed, returning -1
Unregistered channel type 'Tor'
Unregistered channel type 'Zap'
So what have I done wrong, or not done ??
Thanks for reading
--
Clive
Email : clive.carter at sbcs.co.uk
Alt : clivecarter at orange.net
Tel : 0845 0043366
Alt : 01952 402032
SIP : 84416002 at voiptalk.org
Mobile : 07970 856261
More information about the asterisk-users
mailing list