[Asterisk-Users] integrating with existing PBX

[Shlomi Bachar]

Hello,

 I'm trying to setup asterisk with T100P and Adit600 (3FXS & 1FXO), can
you please help with the configuration needed?

Thanks
 Shlomi

-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com] On Behalf Of Andrew
Kohlsmith
Sent: Monday, June 21, 2004 9:29 PM
To: asterisk-users at lists.digium.com
Subject: Re: [Asterisk-Users] integrating with existing PBX

On Monday 21 June 2004 15:19, Florin Andrei wrote:
> Any high-level guidelines on how to integrate Asterisk with a PBX
that's
> already in use? Probably that particular PBX is not supported
directly,
> but are there ways to somehow hook-up to it and route calls from IP to
> PBX or back?

Depending on the number of trunk lines you need and whether you can do
digital 
trunk interfacing: A T1 card (T100P or TE405P) and if you can't do
ct1/PRI 
into your phone system: an FXS channel bank.  I recommend the Adit600 
personally but YMMV.

I recommend the channel bank over using the TDM400P with FXS ports as I
have 
found through my use of the TDM400P at home (3 ports) that the channel
banks 
are by and large more stable and have better voice quality, although
it's a 
fine line.

I'm doing the T100P+Adit600 route on a few Norstart MICS systems right
now, 
and will be converting one of htem to a PRI interface and ditching the 
channel bank to save on wiring and also to experiment with some DID/CLID

experiments with the Norstar system.

Regards,
Andrew
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users