[Asterisk-Users] configuring TE410P for four E1 PRI lines

[Rahul Arvind Jadhav]

Thanks everyone. I changed the jumper settings and it worked fine.

Leo Ann Boon wrote:

> Rahul Arvind Jadhav wrote:
>
>> hi,
>>    I'm trying to configure my newly acquired TE410P card to work as 4 
>> E1 spans. This is
>> supposed to be a drop-in replacement to the earlier E100P card. 
>> However, on loading the
>> zaptel module it gets configured as T1 spans basically doing a 'cat' 
>> on /proc/zaptel/1 thru 4,
>> it shows 24 channels per span. After this ztcfg fails saying 
>> 'ZT_CHANCONFIG failed for channel 97'.
>> This is obviously because Quad T1 has only 96 channels. The question 
>> is how do i get the zaptel module
>> to recognize the card as Quad E1 and not Quad T1.
>> My current /etc/zaptel.conf goes as follows:
>>
>> -----------------------
>>
>> span=1,0,0,ccs,hdb3,crc4
>> span=2,0,0,ccs,hdb3,crc4
>> span=3,0,0,ccs,hdb3,crc4
>> span=4,0,0,ccs,hdb3,crc4
>>
>> bchan=1-15,17-31
>> dchan=16
>> bchan=32-46,48-62
>> dchan=47
>> bchan=63-77,79-93
>> dchan=78
>> bchan=94-108,110-124
>> dchan=109
>>
>> loadzone = us
>> defaultzone = us
>>
>> ----------EOF-------
>>
>> Thanks,
>> Rahul 
>
>
> You need to set the jumpers on the card.
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>

-- 
Rahul Arvind Jadhav
Sr. Software Engineer
NetYantra India Pvt. Ltd
--------------------------