[Asterisk-Users] configuring TE410P for four E1 PRI lines

[Leo Ann Boon]

Rahul Arvind Jadhav wrote:

> hi,
>    I'm trying to configure my newly acquired TE410P card to work as 4 
> E1 spans. This is
> supposed to be a drop-in replacement to the earlier E100P card. 
> However, on loading the
> zaptel module it gets configured as T1 spans basically doing a 'cat' 
> on /proc/zaptel/1 thru 4,
> it shows 24 channels per span. After this ztcfg fails saying 
> 'ZT_CHANCONFIG failed for channel 97'.
> This is obviously because Quad T1 has only 96 channels. The question 
> is how do i get the zaptel module
> to recognize the card as Quad E1 and not Quad T1.
> My current /etc/zaptel.conf goes as follows:
>
> -----------------------
>
> span=1,0,0,ccs,hdb3,crc4
> span=2,0,0,ccs,hdb3,crc4
> span=3,0,0,ccs,hdb3,crc4
> span=4,0,0,ccs,hdb3,crc4
>
> bchan=1-15,17-31
> dchan=16
> bchan=32-46,48-62
> dchan=47
> bchan=63-77,79-93
> dchan=78
> bchan=94-108,110-124
> dchan=109
>
> loadzone = us
> defaultzone = us
>
> ----------EOF-------
>
> Thanks,
> Rahul 

You need to set the jumpers on the card.