[Asterisk-Users] Don't forget the TDM400P power connection

[Brad Bergman]

Could someone elaborate on this a little? I wasn't aware that this was 
necessary.

Quoting Steve Haehnichen <s-asterisk at trix.com>:

> I'm a newbie, not afraid to admit it.  I tried to install my TDM400P
> without the auxilliary (drive) power connection and got this failure
> when loading the wcfxs module:
> 
>    Freshmaker version: 63
>    Freshmaker passed register test
>    ProSLIC on module 0 failed to powerup within 510 ms
>    Unable to do INITIAL ProSLIC powerup on module 0
>    Module 0: Not installed
>    Module 1: Not installed
>    Module 2: Not installed
>    Module 3: Not installed
> 
> A search of the archives turned up nothing, so hopefully it will show
> this message now. :)
> 
> Apparently, this is what happens if a power cable is not connected to
> the side of the card.  I added that connection, and now it probes
> normally:
> 
>    Freshmaker version: 63
>    Freshmaker passed register test
>    Module 0: Initialized
>    Module 1: Not installed
>    Module 2: Not installed
>    Module 3: Not installed
>    Found a Wildcard FXS: Wildcard TDM400P REV E (4 modules)
>    Registered tone zone 0 (United States / North America)
> 
> There was probably a memo somewhere explaining the power socket, but I
> didn't get it.
> 
> -Steve
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>