[Asterisk-Users] Don't forget the TDM400P power connection

[How Peng Kaiam]

I am having problem with the TDM400P.  The ABIT BH6 cannot detect the card
from the BIOS, and loading of module returns "No such address".
Though the card TDM400P can work OK on another Pentium 4 MB.

----- Original Message ----- 
From: "Steve Haehnichen" <s-asterisk at trix.com>
To: <asterisk-users at lists.digium.com>
Sent: Tuesday, September 16, 2003 5:13 PM
Subject: [Asterisk-Users] Don't forget the TDM400P power connection


> I'm a newbie, not afraid to admit it.  I tried to install my TDM400P
> without the auxilliary (drive) power connection and got this failure
> when loading the wcfxs module:
>
>    Freshmaker version: 63
>    Freshmaker passed register test
>    ProSLIC on module 0 failed to powerup within 510 ms
>    Unable to do INITIAL ProSLIC powerup on module 0
>    Module 0: Not installed
>    Module 1: Not installed
>    Module 2: Not installed
>    Module 3: Not installed
>
> A search of the archives turned up nothing, so hopefully it will show
> this message now. :)
>
> Apparently, this is what happens if a power cable is not connected to
> the side of the card.  I added that connection, and now it probes
> normally:
>
>    Freshmaker version: 63
>    Freshmaker passed register test
>    Module 0: Initialized
>    Module 1: Not installed
>    Module 2: Not installed
>    Module 3: Not installed
>    Found a Wildcard FXS: Wildcard TDM400P REV E (4 modules)
>    Registered tone zone 0 (United States / North America)
>
> There was probably a memo somewhere explaining the power socket, but I
> didn't get it.
>
> -Steve
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>