[asterisk-dev] UDPTL sent packet on different port than defined on .conf file !!!

[Klaus Darilion]

In udptl.conf you configure the ports which are used by Asterisk on the 
local side. You can not configure the ports which are used by the remote 
side (the SIP client).

regards
Klaus

Serge Berney schrieb:
> Hello !
> 
>  
> 
> There’s an issue on “UDPTL.c” ; I configured “udptlstart” and 
> “udptlstop” port’s number on “udptl.conf” file.
> 
> Here’s the value on “udptl.conf” :
> 
>  
> 
> [general]
> 
> ; UDPTL start and UDPTL end configure start and end addresses
> 
> udptlstart=3000
> 
> udptlend=3060
> 
>  
> 
> But I’ve this output :
> 
>  
> 
> VERBOSE[9803] logger.c:  Sent UDPTL packet to w.x.y.z:*4940* (type 0, 
> seq 0, len 6)
> 
>  
> 
> As see, port to send packet is not filtered by entered value on .conf file !
> 
> It’s seems that “s->them.sin_port” contain a wrong value ?!?!
> 
>  
> 
> Which parameter/line can I edit to filter port on sending UDPTL packet ?!?!
> 
>  
> 
> Thanks in advance,
> 
>  
> 
> Serge Berney
> *Kin SA
> *Knowledge Integrated Networks
> Rue du Bois-du-Lan 8
> Case Postale 221
> 1217 Meyrin 1
> Tél: +41 22 989 0 999
> Fax: +41 22 989 0 998
> s.berney at kinonline.net <mailto:s.berney at kinonline.net>
> www.kinonline.net <http://www.kinonline.net/>
> 
>  
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> --Bandwidth and Colocation Provided by http://www.api-digital.com--
> 
> asterisk-dev mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-dev