[asterisk-dev] Is full PRI Signaling supported in Asterisk?

[Matthew Fredrickson]

John Lange wrote:
> On Thu, 2007-11-29 at 09:37 -0500, David Boyd wrote:
> 
>> is this an endpoint identifier IE used to route calls to appropriate
>> terminal for ISDN?  This is listed in the ITU Q.932-1998 spec. 
> 
> I wish I knew. Sounds like that might be it but hard to say for certain.
> 
>> The link below should get you there!
>> http://www.itu.int/rec/T-REC-Q.932-199805-I/en
>>
>>
>> If so then you should be able to pull it out of the IE's and handle the
>> routing from there.
> 
> How would you do this? Do you mean by modifying libpri code or that
> there is already a facility for doing this in the dialplan?

The only way to transmit or receive this information would involve 
modifying libpri code.

-- 
Matthew Fredrickson
Software/Firmware Engineer
Digium, Inc.