[test-results] [Bamboo] No agents to build plan LibPRI - 1.4 - Linux - i686 - Default Job

[Bamboo]

-------------------------------------------------------------------------------
PRI-LINUXX686V14-JOB1-31 has been queued, but there's no agent capable of building it.
-------------------------------------------------------------------------------

http://bamboo.asterisk.org/browse/PRI-LINUXX686V14-JOB1/log

--------------
Code Changes
--------------
rmudgett (2273):

>Outgoing BRI calls fail when using Asterisk 1.8 with HA8, HB8, and B410P cards.
>
>France Telecom brings layer 2 and layer 1 down on BRI lines when the line
>is idle.  When layer 1 goes down Asterisk cannot make outgoing calls and
>the HA8 and HB8 cards also get IRQ misses.
>
>The inability to make outgoing calls is because the line is in red alarm
>and Asterisk will not make calls over a line it considers unavailable.
>The IRQ misses for the HA8 and HB8 card are because the hardware is
>switching clock sources from the line which just brought layer 1 down to
>internal timing.
>
>There is a DAHDI option for the B410P card to not tell Asterisk that layer
>1 went down so Asterisk will allow outgoing calls: "modprobe wcb4xxp
>teignored=1".  There is a similar DAHDI option for the HA8 and HB8 cards:
>"modprobe wctdm24xxp bri_teignored=1".  Unfortunately that will not clear
>up the IRQ misses when the telco brings layer 1 down.
>
>* Add layer 2 persistence option to customize the layer 2 behavior on BRI
>PTMP lines.  The new option has three settings: 1) Use libpri default
>layer 2 setting.  2) Keep layer 2 up.  Bring layer 2 back up when the peer
>brings it down.  3) Leave layer 2 down when the peer brings it down.
>Layer 2 will be brought up as needed for outgoing calls.
>
>JIRA AST-598
>


--
This message is automatically generated by Atlassian Bamboo
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.digium.com/pipermail/test-results/attachments/20110817/89702e5f/attachment.htm>