[asterisk-users] chan_sip -> pjsip - address binding

[Joshua C. Colp]

On Wed, Nov 25, 2020 at 11:24 AM marek <cervajs64 at gmail.com> wrote:

> tried chan_sip/udp + pjsip/tcp
>
> but the same problem
>
> sip.conf
>
> [general]
> udpbindport=5060
> udpbindaddr=0.0.0.0
> tcpenable=no
> tlsenable=no
>
> pjsip.conf
> [transport-tcp]
> type = transport
> bind = 2.2.2.2:5070
> protocol = tcp
>
>   Loading res_pjsip.so.
> [Nov 25 16:21:04] ERROR[5528]: res_pjsip/config_transport.c:664
> transport_apply: Transport 'transport-tcp' could not be started: Cannot
> assign requested address
> [Nov 25 16:21:04] ERROR[5528]: res_sorcery_config.c:420
> sorcery_config_internal_load: Could not create an object of type
> 'transport' with id 'transport-tcp' from  configuration file 'pjsip.conf'
>
> anybody know if its possible preload pjsip before chan_sip? (tried
> preload=  but its complicated. a lot of dependecies)
>

You're assuming that the problem is an interaction between chan_sip and
chan_pjsip. If you don't load chan_sip at all, does the problem still
occur? If so then chan_sip isn't the problem but something most likely
system level - since the system stated that PJSIP could not use the
configured address.

-- 
Joshua C. Colp
Asterisk Technical Lead
Sangoma Technologies
Check us out at www.sangoma.com and www.asterisk.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.digium.com/pipermail/asterisk-users/attachments/20201125/9a1d249b/attachment.html>