[asterisk-users] chan_sip -> pjsip - address binding

[marek]

tried chan_sip/udp + pjsip/tcp

but the same problem

sip.conf

[general]
udpbindport=5060
udpbindaddr=0.0.0.0
tcpenable=no
tlsenable=no

pjsip.conf
[transport-tcp]
type = transport
bind = 2.2.2.2:5070
protocol = tcp

  Loading res_pjsip.so.
[Nov 25 16:21:04] ERROR[5528]: res_pjsip/config_transport.c:664 
transport_apply: Transport 'transport-tcp' could not be started: Cannot 
assign requested address
[Nov 25 16:21:04] ERROR[5528]: res_sorcery_config.c:420 
sorcery_config_internal_load: Could not create an object of type 
'transport' with id 'transport-tcp' from  configuration file 'pjsip.conf'

anybody know if its possible preload pjsip before chan_sip? (tried 
preload=  but its complicated. a lot of dependecies)

its Asterisk 13 current

Marek

Dne 25/11/2020 v 14:55 marek napsal(a):
> hi,
>
> i want gradually migrate to pjsip
>
> i have 2 network interfaces with a lot of endpoints on both (both UDP)
> eth0 1.1.1.1
> eth1 2.2.2.2
>
> i want start migrate endpoints to pjsip on 2.2.2.2:5070
>
> but configuration like this is not possible
>
> sip.conf
>
> [general]
> bindaddr = 0.0.0.0
> bindport = 5060
>
> pjsip.conf
> [udp]
> type = transport
> bind = 2.2.2.2:5070
> protocol = udp
>
>
> [Nov 25 14:44:18] ERROR[3442]: res_pjsip/config_transport.c:664 
> transport_apply: Transport 'udp' could not be started: Cannot assign 
> requested address
>
> [Nov 25 14:44:18] ERROR[3442]: res_sorcery_config.c:420 
> sorcery_config_internal_load: Could not create an object of type 
> 'transport' with id 'udp' from configuration file
>
>
> is there some other way?
>
> thanks
>
> Marek
>
>