[asterisk-users] TE410P hardware problems

[Shaun Ruffell]

On Wed, Aug 03, 2011 at 10:36:24PM -0400, Dave George wrote:
> I opened the jumpers on the card putting them in T1 mode and it worked.  I
> had them set to T1 using the options in the dahdi.conf file under
> /etc/modprobe.d/
> 
> That worked well for over a year until it started acting up.

Any chance that in doing this you reseated the card? The jumpers are read by
the driver, which then sets the mode. So when it comes to configuring the card
they are functionally the same.

But regardless, thanks for closing the loop on this.

-- 
Shaun Ruffell
Digium, Inc. | Linux Kernel Developer
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
Check us out at: www.digium.com & www.asterisk.org