[asterisk-users] HA8 + B400M not configured with genconf_parameters

[Olivier]

2010/11/29 Shaun Ruffell <sruffell at digium.com>

>
>
> Does the "modprobe wctdm24xxp" command complete successfully?

 Is there
> anything in dmesg or in the output of dahdi_scan after loading the driver?
>
> Cheers,
> Shaun
>
Hi,

Here is relevant dmesg's output :

[   13.455729] dahdi: Telephony Interface Registered on major 196
[   13.455729] dahdi: Version: 2.4.0
[   13.510847] ACPI: PCI Interrupt 0000:01:0b.0[A] -> GSI 22 (level, low) ->
IRQ 22
[   15.527788] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   17.527787] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   19.527787] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   21.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.

[   23.527784] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   25.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   27.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   29.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   31.527785] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   33.527942] wctdm24xxp 0000:01:0b.0: Timeout waiting for receive frame.
[   33.527995] wctdm24xxp 0000:01:0b.0: The firmware may be corrupted.
Please completely power off your system, power on, and then reload th
e driver with the 'forceload' module parameter set to 1 to attempt recovery.
[   33.544741] ACPI: PCI interrupt for device 0000:01:0b.0 disabled
[   33.544757] wctdm24xxp: probe of 0000:01:0b.0 failed with error -5
[   34.157817] dahdi: Registered tone zone 2 (France)
[   38.873158] warning: `ntpd' uses 32-bit capabilities (legacy support in
use)
[   47.462040] dahdi: Detected time shift.


My setup is :
Asterisk box with HA8+B400M  <---ISDN/BRI----> Patton SN4638 <----SIP--->
Asterisk

Patton SN4638 is configured to behave as telco node (ie NT/PtmP).


PS: As a side note, I originally included the "modprobe wctdm24xxp" command
in a shell script configured with "set -e" option.
I will further check the modprobe exit code when such " wctdm24xxp: probe of
0000:01:0b.0 failed with error -5" is produced.

Regards
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20101130/71610daa/attachment.htm