[asterisk-users] HA8 + B400M not configured with genconf_parameters

[Shaun Ruffell]

On 11/26/2010 05:05 AM, Olivier wrote:
> Hi,
> 
> On a Lenny system, with dahdi 2.4.0, libpri 1.4.11.5 and asterisk
> 1.6.1.18,  I inserted a new Digium HA8 + B400M card.
> My usual installation fails.
> 
> 
> I can see it listed :
> # lspci -n | grep d161
> 01:0b.0 0200: d161:8007 (rev 11)
> 
> # lspci -vn
> 01:0b.0 0200: d161:8007 (rev 11)
>         Subsystem: d161:8007
>         Flags: medium devsel, IRQ 22
>         I/O ports at d400 [size=256]
>         Memory at fe5fe800 (32-bit, non-prefetchable) [size=1K]
>         Expansion ROM at 20020000 [disabled] [size=128K]
>         Capabilities: [c0] Power Management version 2
>         Kernel modules: wctdm24xxp
> 
> # lsdahdi
> # modprobe wctdm24xxp
> # dahdi_genconf -v modules
> Default parameters from /etc/dahdi/genconf_parameters
> Generating /etc/dahdi/modules
> # cat modules
> # Autogenerated by /usr/sbin/dahdi_genconf (Dahdi::Config::Gen::Modules)
> on Fri Nov 26 12:02:11 2010
> # If you edit this file and execute /usr/sbin/dahdi_genconf again,
> # your manual changes will be LOST.
> wctdm24xxp
> # dahdi_genconf -v system
> Default parameters from /etc/dahdi/genconf_parameters
> Empty configuration -- no spans
> Generating /etc/dahdi/system.conf
> 
> 
> Is there something I could do to change this ?

Does the "modprobe wctdm24xxp" command complete successfully?  Is there
anything in dmesg or in the output of dahdi_scan after loading the driver?

Cheers,
Shaun

-- 
Shaun Ruffell
Digium, Inc. | Linux Kernel Developer
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
Check us out at: www.digium.com & www.asterisk.org