[asterisk-users] Urgent Help Required

[ali anjum]

Hi,
 
(I have install trixbox2.8 with asterisk 1.6)
I am using speex codec for my Inter asterisk communication

Question1: I want to configure speex on 2.15kbs and packetization of 60ms seconds for that is have configured "codecs.conf" for desired result and also placed a line in general section of "sip.conf" allow=speex:60 after disallow=all line . 

I have also configure SIP trunk between two asterisk to use speex:60
During debugging I have checked that both side accept speex as a codec for call and ptime:60 but

I am facing following unexpected results

1-> When I check the packet rate from one asterisk to other asterisk for one call its not (1000/60 == 17)?

2-> When ever I change the softphone result changes i.e. data ratae chages ?

3-> How can I use my own codec "xyz" in asterisk to place calls ?

4->if I change the codecs.conf then no results appears in packet size which is comming out of asterisk?

 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20101104/50e8db6d/attachment.htm