[asterisk-users] New Xorcom FXS USB Bank is not loading firmware

[Loic Didelot]

Hello,
now I can reset and load the firmware, but I do not see the entries
in /proc and the genzaptel command ignores the astribank. The dual PRI
card works fine.

root at pbx1:~# zaptel_hardware 
usb:002/002          xpp_usb-     e4e4:1161 Astribank-modular
USB-firmware
pci:0000:01:05.0     wct4xxp+     d161:0210 Wildcard TE210P 

root at pbx1:~# ls /proc/zaptel/*
/proc/zaptel/1  /proc/zaptel/2



Best regards,
Loïc.


On Fri, 2009-09-25 at 20:01 +0300, Tzafrir Cohen wrote:
> On Fri, Sep 25, 2009 at 04:30:19PM +0200, Loic Didelot wrote:
> > # lsusb 
> > Bus 002 Device 003: ID e4e4:1160  
> > Bus 002 Device 001: ID 0000:0000  
> > Bus 001 Device 003: ID 0403:e6c8 Future Technology Devices
> > International, Ltd 
> > Bus 001 Device 002: ID 0403:6001 Future Technology Devices
> > International, Ltd FT232 USB-Serial (UART) IC
> > Bus 001 Device 001: ID 0000:0000  
> > # ls /proc/bus/usb -a
> > .  ..
> 
> Add the following line to /etc/fstab:
> 
> procbususb /proc/bus/usb usbfs defaults 0 0
> 
> 
> Then run:
> 
>   mount /proc/bus/usb
> 
> (or: 'mount -a')
> 
> Once that is in place, either disconnect and reconnect the Astribank, or
> use:
> 
>   /usr/share/dahdi/xpp_fxloader usb
>