[asterisk-users] US Caller ID

[Andrew Joakimsen]

The *BEST* solution would be to have Verizon switch you over to a PRI.

On Wed, Apr 29, 2009 at 17:29, Daniel Hazelbaker
<daniel at highdesertchurch.com> wrote:
> Okay, I can't find what might be causing this.  Here is what I got:
>
> Asterisk server hooked up to a digital T1 line (full 24-channel) via a
> Digium card.
> Verizon has turned on caller ID on the first line (I can guarantee it
> is on as I can hear the FSK tones on this line but not the others).
> Using zttool an ZapScan() I have determined the following:
>
> 1) The RxB/RxD bits toggle from 1 to 0 signaling a ring.
> 2) A short time later, via ZapScan() I can hear the FSK tone.
> 3) About the same time I hear the FSK tone I see the "Starting simple
> switch" line in the Asterisk console.
> 4) Next I see the second ring trigger in zttool and then Asterisk say
> "ss_thread: Got event 18 (Ring Begin)".
>
> Caller ID never shows up.  I have tried cranking the rxgain up
> thinking maybe it was too quiet for Asterisk to detect but that did
> not help.  My caller id settings in zapata.conf are:
>
> usecallerid=yes
> callerid=asreceived
> cidsignalling=bell
> cidstart=ring
> signalling=fxs_ks
>
> Is there any existing debug options I can turn on, or do I need to add
> some to try and figure out what is going on; or does somebody have an
> instant answer for me?
>
> Thanks,
> Daniel
>
> _______________________________________________
> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
>
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>