[asterisk-users] libpri and NT-Point to multi-point

[Andrew Thomas]

If you are connecting to BRI lines then you should be TE - not NT.

You can run as TE ptp or ptmp with mISDN (not sure about DAHDI yet - not tried the new release).

HTH

 

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Olivier
Sent: 17 December 2008 08:14
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [asterisk-users] libpri and NT-Point to multi-point

Hi,

At the moment, libpri /w Asterisk 1.6, Dahdi 2.1, is not supporting NT-Point to multi-point mode.
Here (France), most small PBXes are connected to ISDN through BRI trunks in PtmP (don't know why but it seems the general case).
So this NT-PtmP function would be very helpful to easily slide an Asterisk box between an existing PBX and the network.

Does the same case apply elsewhere (UK, Germany, Italy, ...) ?
Do you think this is needed ?

Regards