[asterisk-users] chan problem

[Bob Chiodini]

linux at shelob.nl wrote:
> I experienced the same problem. The only way I could get both
> ISDN and analog working was unloading kernel modules for zaptel
> and mISDN after boot and then load them in the order:
> zaptel first and then mISDN. Still need to find out how to configure
> load order in linux.
>
> grz,
>
> Hans Feringa
>
>
>
>   
>> On Mon, Jun 18, 2007 at 12:50:23PM +0200, Josu Lazkano wrote:
>>     
>>> Hello everybody!
>>>
>>> I have some problems with my Astersk. I have an analogical OpenVox card
>>> and
>>> A Billion ISDN card (with mISDN).
>>>
>>> I load the modules with modprobe zaptel and modprobe wctdm.
>>>
>>> When I run ztcfg -vv I have this:
>>>
>>> Zaptel Configuration
>>> ======================
>>>
>>>
>>> Channel map:
>>>
>>> Channel 01: FXS Kewlstart (Default) (Slaves: 01)
>>>
>>> 1 channels configured.
>>>
>>> ZT_CHANCONFIG failed on channel 1: No such device or address (6)
>>>       
>> This means your /etc/zaptel.conf is incorrect. Start by correcting it.
>> Or maybe the driver has not loaded correctly.
>>
>> Which OpenVox card is it?
>>
>> What is the output of:
>>
>>   lspci
>>   cat /proc/zaptel/*
>>
>>     
>>> zaptel.conf:
>>>
>>> loadzone=es
>>> defaultzone=es
>>> fxsks=1
>>>       
>> -

Hans,

Have a look at the man page for modprobe.conf, specifically the install directive.  There is an example of how to force the order.

Bob...