[asterisk-users] TDM400 with 1 FXO

[MBIT Technologies]

Hi David

Also make sure the power connector is also connected to the board.
 

Regards
 
 
Mark Brooker
T: 02 4959 8670
M: 0415 846 865
F: 02 4950 5609
E: mark at mbit.com.au
W: http://www.mbit.com.au
 

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Klaverstyn,
David C
Sent: Friday, 9 February 2007 1:08 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: RE: [asterisk-users] TDM400 with 1 FXO

Hi,

Yes it should, I have changed it back and is still causing the same
problems.



-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Leo Ann
Boon
Sent: Friday, 9 February 2007 12:02 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] TDM400 with 1 FXO


Klaverstyn, David C wrote:
>
> Hi All,
>
>  
>
> I cannot get my TDM to work correctly.
>
>  
>
> In my /etc/zaptel.conf file I have
>
> loadzone = us
>
> defaultzone=us
>
>  
>
> fxoks=1
>
Shouldn't this be fxsks if you're using an FXO module as analog trunk?

Leo

_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users