[asterisk-users] New user question (X100P)

[Tzafrir Cohen]

On Mon, Feb 05, 2007 at 05:51:44PM -0500, David Ruggles wrote:
> I'm trying to set up a simple test box to start developing with Asterisk.
> 
> I've got a Dell GX150 with two X100P cards. I've downloaded, printed out and
> read through most of TFOT. I've also done a lot of Internet searching.
> 
> I'm getting this error:
> ZT_CHANCONFIG failed on channel 1: No such device or address (6)

This error message is specifically from running ztcfg.

> 
> Based on the searching I've done, it seems like the problem must be shared
> IRQ issues. I've gone in the BIOS and disabled everything I can but I can't
> stop the sharing completely. One X100P is shared with the built-in video and
> the other X100P is shared with a serial controller. (I disabled both serial
> ports)
> 
> My question is this: (in three parts)
> 
> 1) Are my research and assumptions accurate? Does this seem to be an IRQ
> issue?

Maybe. What do you have in /proc/zaptel/* ? What in /etc/zaptel.conf ?
The difference between the two is the immediate cause for the error.

> 2) If I have to build another system to prevent the IRQ problem, can anyone
> recommend hardware (just for a simple test box right now)

Maybe. We have no idea what your system is like. So thisstill remains a
theory.

What do you see in the kernel logs e.g: dmesg| tail ) after loading the
module wcfxo ?

What linux distribution do you use, anyway?

-- 
               Tzafrir Cohen       
icq#16849755                    jabber:tzafrir at jabber.org
+972-50-7952406           mailto:tzafrir.cohen at xorcom.com       
http://www.xorcom.com  iax:guest at local.xorcom.com/tzafrir