[asterisk-users] Incorrect Ring tone. Getting a US tone when itshould be AU tone

[Paul Hales]

Sounds like some nice work - we are currently finishing off a 200 seat
call centre....which has just been _hard_ work.

PaulH

On Tue, 2006-10-31 at 02:32 +0800, Craig Guy wrote:
> Hi David,
> 
> It can be set on the Sipura / Linksys devices.  Look under Admin, Advanced, 
> Regional, Call Progress Tones.  There is a link floating around on Whirlpool 
> forums to a page and auto provision file containing the correct settings to 
> produce Australian tones.  It also depends on whether the phone allows the 
> PBX to make the progress tones or whether the phone alone does them.  The 
> setting to control this is in Sipura/Linksys firmware 3.1.10 and higher from 
> memory.  If you want the handset to do the tones, or you get a 'double 
> ringing' in the handsets of these phones / ATA's then set Admin / Advanced / 
> Line X / SIP Settings / Sticky 183 to no.
> 
> Btw, how's your Asterisk going?  I'm in the middle of doing a 7 site Least 
> Cost Routed DUNDi setup with redundant routes - Good fun though the learning 
> curve is a bit steep.
> 
> Craig