[asterisk-users] Incorrect Ring tone. Getting a US tone when itshould be AU tone

[Craig Guy]

Hi David,

It can be set on the Sipura / Linksys devices.  Look under Admin, Advanced, 
Regional, Call Progress Tones.  There is a link floating around on Whirlpool 
forums to a page and auto provision file containing the correct settings to 
produce Australian tones.  It also depends on whether the phone allows the 
PBX to make the progress tones or whether the phone alone does them.  The 
setting to control this is in Sipura/Linksys firmware 3.1.10 and higher from 
memory.  If you want the handset to do the tones, or you get a 'double 
ringing' in the handsets of these phones / ATA's then set Admin / Advanced / 
Line X / SIP Settings / Sticky 183 to no.

Btw, how's your Asterisk going?  I'm in the middle of doing a 7 site Least 
Cost Routed DUNDi setup with redundant routes - Good fun though the learning 
curve is a bit steep.

Craig

----- Original Message ----- 
From: "Klaverstyn, David C" <David.Klaverstyn at intergraph.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" 
<asterisk-users at lists.digium.com>
Sent: Monday, October 30, 2006 5:06 PM
Subject: RE: [asterisk-users] Incorrect Ring tone. Getting a US tone when 
itshould be AU tone


I don't think it is a phone problem.  I get a US ring tone on a PAP2,
SPA-942 and IDEFdisk softphone.

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Paul Hales
Sent: Monday, 30 October 2006 5:08 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] Incorrect Ring tone. Getting a US tone
whenit should be AU tone


What phones are you using? It could be a phone level issue.
(my aastra has a setting for AU sounds..)

PaulH

On Mon, 2006-10-30 at 16:13 +1100, Klaverstyn, David C wrote:
> For some reason Asterisk is producing a US ring tone when it should be
> an Australian ring tone.  I am using ztdummy and do not have any cards
> installed.  My configuration is as follows.  I am using Trixbox
> 1.2.2.   Can someone please guide me into the right direction?
>
>
>
> zaptel.conf
>
> loadzone = au
>
> defaultzone = au
>
>
>
> zapata.conf
>
> [channels]
>
> language=au
>
>
>
> indications.conf
>
> [general]
>
> country=au
>
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users

_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users