[Asterisk-Users] TDM

[Steve Totaro]

Connect to the Asterisk console with verbose turned on and try to dial.  
Post that output. 

Curt Shaffer wrote:
> This is not *@H it is asterisk with FreePBX only. Yes the phone line is
> connected to the right port. No luck. Thanks.
>
> -----Original Message-----
> From: asterisk-users-bounces at lists.digium.com
> [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of John Novack
> Sent: Saturday, May 27, 2006 11:02 PM
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: Re: [Asterisk-Users] TDM
>
>
>
> Steve Totaro wrote:
>
>   
>> Is your machine seeing the card? /var/log/messages? Are you loading 
>> the zaptel drivers? modprobe zaptel, modprobe wctdm?
>>
>>     
> Would he get the ztcfg message if it were not?
> Is the phone line plugged into the correct jack?
> With only one module installed, the other three jacks lead to nowhere.
> Also this seems to be Asterisk at home from the references, so perhaps 
> there is a context issue that the configuration files address.
> AAH can really lead one down the garden path!
>
> John Novack
>
>   
>> Curt Shaffer wrote:
>>
>>     
>>> The TDM01B is 4 port capable but has only 1 FXO module. I'm running 
>>> asterisk 1.2.7 and zaptel 1.2.5. I cannot seem to get the TDM01B 
>>> working. When I do the zttool it shows 4/1/0. I can dial out from a 
>>> POTS phone up to the point that the cable plugs into the card.
>>>
>>> Here is my /etc/zaptel.conf
>>>
>>> loadzone=us
>>>
>>> fxsks=1
>>>
>>> and here is my /etc/Zapata.conf
>>>
>>> [channels]
>>>
>>> language=en
>>>
>>> #include zapata_additional.conf
>>>
>>> context=from-zaptel
>>>
>>> signalling=fxs_ks
>>>
>>> faxdetect=incoming
>>>
>>> usecallerid=asreceived
>>>
>>> echocancel=yes
>>>
>>> callprogress=no
>>>
>>> busydetect=no
>>>
>>> echocancelwhenbridged=no
>>>
>>> echotraining=800
>>>
>>> group=0
>>>
>>> channel=>1
>>>
>>> When I dial in Asterisk does not even show an initiation of the call. 
>>> When I dial out on that trunk I get all circuits busy. Ztcfg -vvv 
>>> shows the following
>>>
>>> ztcfg -vvv
>>>
>>> Zaptel Configuration
>>>
>>> ======================
>>>
>>> Channel map:
>>>
>>> Channel 01: FXS Kewlstart (Default) (Slaves: 01)
>>>
>>> 1 channels configured.
>>>
>>> Any help would be appreciated.
>>>
>>> Curt 
>>>       
>>     
>
>