[asterisk-biz] RE: [Asterisk-Users] OT: AudioCodes
MP124-C/FSX/AC/SIP
Erick Perez
eaperezh at gmail.com
Thu May 25 06:49:48 MST 2006
Jerry and Michael, many many thanks for your posts.
Erick.
On 5/24/06, The VoIP Connection <asterisk-biz at thevoipconnection.com> wrote:
> Here are the step by step instructions for setting up a brand new Audiocodes
> FXS gateway for use with an Asterisk server:
>
> Connect the gateway to a network switch and connect a computer to the same
> switch. Then configure the IP address of the computer to 10.1.10.2. Then run
> your web browser and point it to http://10.1.10.10 and login using the
> information below.
>
> Default IP address: 10.1.10.10
> Default user name: Admin
> Default password: Admin
>
> Goto "Quick Setup" and change the following:
> IP Address => Set to the new IP address of the AudioCodes gateway
> Subnet Mask => Set to the correct netmask for your local network
> Default Gateway Address => Set to the correct gateway IP address for your
> local network
> Working With Proxy => Set to "Yes"
> Proxy IP Address => Set to the IP address of the Asterisk server
> Enable Registration => Set to "Enable"
>
> Restart the gateway then log back in using the new IP address.
>
> Goto Protocol Management -> Protocol Definition -> Proxy & Registration
> Registrar IP Address => Set to the IP address of the Asterisk server
> Registration Time => Set to "60"
> Subscription Mode => Set to "Per Endpoint"
> Authentication Mode => Set to "Per Endpoint"
>
> Goto Protocol Management -> Protocol Definition -> DTMF & Dialing
> Max Digits In Phone Num => Set to a large enough number such as "32"
>
> Goto Protocol Management -> Protocol Definition -> Coders
> Add coders as needed You need to set at least G.711U-law
>
> Goto Protocol Management -> Endpoint Settings -> Authentication
> Set SIP username and password for each port
>
> Goto Protocol Management -> Endpoint Phone Numbers
> Enter an extension (phone) number for every used channel
>
> Your AudioCodes gateway is now ready.
>
> Michael Crown
> Managing Partner
> www.thevoipconnection.com
> 321.989.6728 ext. 611
> sip:611 at voiceserver.thevoipconnection.com
>
> > -----Original Message-----
> > From: billy at kersting.com [mailto:billy at kersting.com]
> > Sent: Wednesday, May 24, 2006 10:23 PM
> > To: asterisk-biz at thevoipconnection.com
> > Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
> >
> > FXS
> >
> > -----Original Message-----
> > From: asterisk-users-bounces at lists.digium.com
> > [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of
> > The VoIP Connection
> > Sent: Wednesday, May 24, 2006 9:25 PM
> > To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
> > Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
> >
> > FXS or FXO?
> >
> > Michael Crown
> > Managing Partner
> > www.thevoipconnection.com
> > 321.989.6728 ext. 611
> > sip:611 at voiceserver.thevoipconnection.com
> >
> >
> > > -----Original Message-----
> > > From: William Piper [mailto:billy at kersting.com]
> > > Sent: Wednesday, May 24, 2006 6:27 PM
> > > To: 'Asterisk Users Mailing List - Non-Commercial Discussion'
> > > Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
> > >
> > > Sorry to hijack your thread.
> > >
> > > Reading these posts made me grab my old MP-104 & try again
> > to get it
> > > working with asterisk. I bought it a while ago off eBay &
> > never could
> > > get it to register.
> > >
> > > Does anyone have an example ini file for the MP-1XX that I
> > could look
> > > at & figure out what I am configuring wrong on this box?
> > >
> > > Thanks,
> > >
> > > bp
> > >
> > > -----Original Message-----
> > > From: asterisk-users-bounces at lists.digium.com
> > > [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Jerry
> > > Jones
> > > Sent: Wednesday, May 24, 2006 6:04 PM
> > > To: Asterisk Users Mailing List - Non-Commercial Discussion
> > > Subject: Re: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP
> > >
> > > From my copy of the manual
> > >
> > >
> > > MP-1xx SIP User's Manual 36 Document #: LTRT-65404 You can use the
> > > 'Reset' button to restore the MP-1xx networking parameters to their
> > > factory default values (described in Table 4-1) and to reset the
> > > username and password.
> > > Note that the MP-1xx returns to the software version burned
> > in flash.
> > > This process also restores
> > > the MP-1xx parameters to their factory settings, therefore you must
> > > load your previously backed- up ini file, or the default ini file
> > > (received with the software kit) to set them to their
> > correct values.
> > > To restore networking parameters to their initial state,
> > take these 6
> > > steps:
> > > 1. Disconnect the MP-1xx from the power and network cables.
> > > MP-1xx SIP User's Manual 4. Getting Started 2. Reconnect the power
> > > cable; the gateway is powered up. After approximately
> > > 45 seconds the Ready LED turns to green and the Control LED
> > blinks for
> > > about 3 seconds.
> > > 3. While the Control LED is blinking, press shortly on the reset
> > > button (located on the left side of the front panel); the gateway
> > > resets a second time and is restored with factory default
> > parameters
> > > (username: "Admin", password: "Admin").
> > > 4. Reconnect the network cable.
> > > 5. Assigning the MP-1xx IP address (refer to Section 4.1
> > on page 35).
> > > 6. Load your previously backed-up ini file, or the default ini file
> > > (received with the software kit).
> > > To load the ini file via the Embedded Web Server, refer to
> > Section
> > > 5.9.2.1 on page 120.
> > >
> > >
> > >
> > >
> > > On May 24, 2006, at 3:00 PM, Erick Perez wrote:
> > >
> > > > Just a question, has anyone knows how to blank or factory
> > reset an
> > > > AudioCodes MP124-C/FSX/AC/SIP unit (it's a 24 FSX to SIP unit).
> > > > I purchased them second-handed with no manuals (thank god for the
> > > > internet!!) but i guess the pdf manual I have does not have the
> > > > section of factory-reset.
> > > >
> > > > Also, any sucess stories with:
> > > > AudioCodes MP124-C/FSX/AC/SIP
> > > <--->Asterisk<---internet<--->Vonage
> > > > setups?
> > > >
> > > > Thanks,
> > > >
> > > >
> > > > --
> > > >
> > > > -------------------------------------------
> > > > Erick Perez
> > > > Linux User 376588
> > > > http://counter.li.org/ (Get counted!!!) Panama, Republic
> > of Panama
> > > > _______________________________________________
> > >
> > >
> > >
> > >
> >
> > _______________________________________________
> > --Bandwidth and Colocation provided by Easynews.com --
> >
> > Asterisk-Users mailing list
> > To UNSUBSCRIBE or update options visit:
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> >
> >
> > __________ NOD32 1.1556 (20060525) Information __________
> >
> > This message was checked by NOD32 antivirus system.
> > http://www.eset.com
> >
> >
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-biz mailing list
> To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-biz
>
--
-------------------------------------------
Erick Perez
Linux User 376588
http://counter.li.org/ (Get counted!!!)
Panama, Republic of Panama
More information about the asterisk-users
mailing list