[Asterisk-Users] ZT_CHANCONFIG failed on channel 2: , Guidance requested

[John Joseph]

--- yusuf <yusuf at ecntelecoms.com> wrote:

> John Joseph wrote:
> > Hi 
> >     O
> > 
> Hi ,
> 
> this could a simple thing where you are mixing up
> signalling types for 
> FXO and FXS.
> 
> for example if i have 2 FXO (red)and 2 FXS (green)
> 
> the FXO is setup with FXS signailling and FXS with
> FXO signalling
> 
> so if my channels 1 and 2 is green and,
>   3 and 4 is red
> 
> rmmod wctdm
> rmmod zaptel
> 
> [zaptel.conf]
> fxoks=1-2
> fxsks=3-4
> 
> 
> [zapata.conf]
> 
> signalling=fxo_ks
> channel =>1-2
> signalling=fxs_ks
> channel =>3-4
> 
> 
> modprobe zaptel
> modprobe wctdm
> 
> 
> hope this helps
> yusuf
> 
> 
> 
Hi Yusuf 
      Thanks for the mail 
  I think it is not the case of mixing up of signaling
, because 
even before  editing zaptel.conf and zapta.conf , when
I run modprobe , I get one time this error entering
“modprobe wctdm “ second time does not throw errors 
This is what I get when I give modprobe

[root at joseph etc]# modprobe zaptel
[root at joseph etc]# modprobe wctdm
ZT_CHANCONFIG failed on channel 1: No such device or
address (6)
FATAL: Error running install command for wctdm
[root at joseph etc]# modprobe wctdm
[root at joseph etc]#

see , first time the modprobe wctdm throws error ,
second time , it does not 
                       I am  using RHEL4 ,  Digium
card Wildcard X101P board
  
                          Guidance requested 
                                    Thanks 
                                         Joseph John 



		
___________________________________________________________ 
Win a BlackBerry device from O2 with Yahoo!. Enter now. http://www.yahoo.co.uk/blackberry