[Asterisk-Users] pri gateway

[Baris Simsek]

Hello,

I haven't solved following problem yet. I worry that:

CLI> pri intense debug span

There is no any debug information. Does it give any idea about problem?

Baris Simsek wrote:

> hi,
>
> my asterisk version is 1.0.9
>
> /etc/zaptel.conf
> span=1,1,0,ccs,hdb3,crc4
> bchan=1-15
> dchan=16
> bchan=17-31
>
> it is comfortable with Turkish Telecom. i tried before and it works.
>
> /etc/asterisk/zapata.conf
> [channels]
> switchtype=euroisdn
> signalling=pri_cpe
> context=incoming
> group=1
> channel=>1-15,17-31
>
> Leds are lighting at start. When i run /etc/init.d/zaptel they go out. 
> And i can see the modules are installed. and i see that, layer 1 is 
> going up after zaptel. So i am sure there is no problem with drivers. 
> I think it is connected to asterisk. any idea? thanks...
>
> altus wrote:
>
>> what about a copy of your zapata.conf and zaptel.conf,what color is the
>> leds
>>
>> On Thu, 2005-09-08 at 12:42 +0300, Baris Simsek wrote:
>>  
>>
>>> hello,
>>>
>>> i installed an asterisk as  a pri gateway. Everything is okay. 
>>> /etc/init.d/zaptel starts successfull with wct4xxp module. 
>>> /etc/init.d/asterisk starts also successfully. I tested my pri cable 
>>> and it works. But still my span isn't up. I don't see any error. Do 
>>> you have any idea? What else i should check? Thanks.
>>>
>>> My card is 4 span Wildcard TE410P 
>>> <http://www.digium.com/index.php?menu=product_detail&category=hardware&product=TE410P> 
>>>
>>>
>>> # lsmod
>>> wct4xxp               106688  62
>>> zaptel                226820  129 wct4xxp
>>>
>>> # asterisk -r
>>> gw*CLI> pri show span 1
>>> Primary D-channel: 16
>>> Status: Provisioned, In Alarm, Down, Active
>>> Switchtype: EuroISDN
>>> Type: CPE
>>> Window Length: 0/7
>>> Sentrej: 0
>>> SolicitFbit: 0
>>> Retrans: 0
>>> Busy: 0
>>> Overlap Dial: 0
>>> T200 Timer: 1000
>>> T203 Timer: 10000
>>> T305 Timer: 30000
>>> T308 Timer: 4000
>>> T313 Timer: 4000
>>> N200 Counter: 3
>>