[Asterisk-Users] SIPURA SPA-2000 webserver dead after firmware upgrade

[Joseph]

I have a SPA-3000 and Netgear switch; when I run an upgrade on SPA-3000
with Netgear switch in between my SPA-3000 stopped functioning; I send
it back and got a new unit.  However, later on I run onto a post (on
Voxilla) that warned not to use Netgear switch to upgrade Sipura unit.  
Indeed, I use my old hub to upgrade the new unit and it went smooth.

-- 
#Joseph

On Tue, 2005-05-10 at 21:50 -0400, Steve Prior wrote:
> I just got a refurb Sipura SPA-2000 and was able to assign it an IP
> address with DHCP and ping the device, but then I ran the firmware 
> upgrade utility to bring it up to spa2k-2.0.13g which seemed to
> work just fine, but after it rebooted I cannot connect to its
> webserver for configuration.  I can still ping the unit.  When
> I use the built in voice menu it reads back the right IP address,
> webserver port, and claims the webserver is enabled, but I can't
> connect to port 80 on the device and running the firmware upgrade
> utility says that it cannot connect to the unit either.
> 
> Has anyone seen something like that and is there a fix?  A google
> search didn't turn up any apparent hits.
> 
> Thanks
> Steve