[Asterisk-Users] T1 DSU's/Split for voice

[Damon Estep]

> -----Original Message-----
> From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-
> bounces at lists.digium.com] On Behalf Of Paul
> Sent: Sunday, August 28, 2005 7:48 AM
> To: Asterisk Users Mailing List - Non-Commercial Discussion
> Subject: Re: [Asterisk-Users] T1 DSU's/Split for voice
> 
> gw at adcomcorp.com wrote:
> 
> >Hello All,
> >I was wondering if I could do the following on asterisk...
> >
> >Get a T1 between 2 locations, and split it into a data channel of
like
> >1024, and use the rest for voice channels.
> >
> >Has anyone done this and had it working well?  Or would I need to get
a
> >csu that allows a split into two interfaces?
> >
> >Regards,
> >Greg
> >
> >
> On a point-to-point t you will need hardware to split channels at both
> ends.
> 
> Since you posted to this list I assume that * is used at least on one
> end of the t1. If you use good routers that can prioritize voip
traffic
> then all you need is ata's and/or ip phones at the other end. That
gives
> you more data bandwidth when the phones are not in use. Segregating
n/24
> of your t is not so flexible.
> 
That would be one way to do it, but both the Digium cards and the
sangoma cards can be configured to route some of the 24 timeslots on a
T1 to voice and some to data.