[Asterisk-Users] Re: can't make my PRI dial out

[Edwin Groothuis]

On Fri, Apr 22, 2005 at 11:10:43AM -0500, asterisk-users-request at lists.digium.com wrote:
> I have a full PRI installed on my * machine. I can get inbound calls 
> just fine but can't make outbound ones.

If you run "pri debug span x", you might see this behaviour:

	PRI debugging with the inbound numbers show that there is
	a minor difference in the SETUP frame:
	In the Channel ID, Telstra hasn't set the exclusive bit,
	AAPT has.

Solution for me was in zapata.conf:

	- spanmap => 1,1,1
	+ spanmap => 1,1

Edwin

-- 
Edwin Groothuis      |            Personal website: http://www.mavetju.org
edwin at mavetju.org    |          Weblog: http://weblog.barnet.com.au/edwin/