[Asterisk-Users] Help with busydetect (no hangups)

[Gelson Dias Santos]

	I´m using * 0.9.0 and have a X100P connected to my analog PBX. I can´t 
detect hangups on this line, so I turned on busydetect=yes in 
zapata.conf. I also have busycount=6.
	While the line is connected to the PBX, I can never detect busy and the 
line hangs at the end of every call. If I connect the same X100P to the 
telco line, without the PBX, then it can detect busy and hangs up the 
line after 6 busy tones, as expected.
	I have recorded the busy tones and found that telco uses a standar one 
(250ms tone, 250 ms silence). My PBX, however, is using a 120ms tone, 
80ms silence sequence.
	How can I adjust the detection routines to the tone I´m getting?  I 
have tried to mess with busy_min, busy_max etc on dsp.c with no luck. 
I´m sure I doesnt really understand the meaning of those parameters.
	A also tryed to compile using TONE_ONLY  but it gives a compilations error.
	Can someone suggest what times should I been using?

	Thanks a lot.

	Gelson