[Asterisk-Users] pri with TE410P not working (Austria)

[Peter Svensson]

On Thu, 17 Jun 2004, Wolfgang Pichler wrote:

> > Are you sure the cables are correct? 
> > Have you set the jumpers on the card to E1 and not left them on T1?
> The jumpers are on E1 - the cables should be ok (they are working with
> other hardware) - and the card is directly connected to a simens ULAF+
> STU Desktop (can't really find much information about this device on the
> net) - which turns off a red led when i load the driver and do a ztcfg.

Then the tx (from TE410P to the Siemens equipment) circuit is ok but the 
rx may not be.

> > I think the leds should turn green when the card senses a correct carrier
> > and framing on the lines.
> green is always a wounderful color ;-)
> 
> so, what else could cause this ?

I'd try to find out if the cable is wired the way the TE410P expects it to 
be. Do you know the pinout of both ends of the cables? RX (from the TE410P 
point of view) should be on the pins 1-2 at the TE410P end and TX on 4-5.

Peter
--
Peter Svensson      ! Pgp key available by finger, fingerprint:
<petersv at psv.nu>    ! 8A E9 20 98 C1 FF 43 E3  07 FD B9 0A 80 72 70 AF
------------------------------------------------------------------------
Remember, Luke, your source will be with you... always...