[Asterisk-Users] pri with TE410P not working (Austria)

[Michael Bielicki]

What is in your config file ?
zaptel.conf ?
also, check the crc4 settings
and
maybe the wire you are using is wrong since some equippment needs
crossed wires, some needs straight wires. Crossed would be 1-4 2-5

cheers

Michael

On Thu, 2004-06-17 at 10:28, Wolfgang Pichler wrote:
> Am Do, den 17.06.2004 schrieb Peter Svensson um 9:43:
> > On Thu, 17 Jun 2004, Wolfgang Pichler wrote:
> > 
> > > ... on the card i can see the two leds pulsing red (i think thats the
> > > yellow alaram - or i am wrong) ?
> > 
> > Are you sure it is not a red alarm? That would indicate a loss of link. 
> > I think you can check with the command zttool. 
> you are right - its a red alarm - zttool says "Red Alarm/Not Open"
> > 
> > Are you sure the cables are correct? 
> > Have you set the jumpers on the card to E1 and not left them on T1?
> The jumpers are on E1 - the cables should be ok (they are working with
> other hardware) - and the card is directly connected to a simens ULAF+
> STU Desktop (can't really find much information about this device on the
> net) - which turns off a red led when i load the driver and do a ztcfg.
> > 
> > I think the leds should turn green when the card senses a correct carrier
> > and framing on the lines.
> green is always a wounderful color ;-)
> 
> so, what else could cause this ?
> 
> wolfgang
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users