[Asterisk-Users] pri with TE410P not working (Austria)

[Wolfgang Pichler]

Am Do, den 17.06.2004 schrieb Peter Svensson um 9:43:
> On Thu, 17 Jun 2004, Wolfgang Pichler wrote:
> 
> > ... on the card i can see the two leds pulsing red (i think thats the
> > yellow alaram - or i am wrong) ?
> 
> Are you sure it is not a red alarm? That would indicate a loss of link. 
> I think you can check with the command zttool. 
you are right - its a red alarm - zttool says "Red Alarm/Not Open"
> 
> Are you sure the cables are correct? 
> Have you set the jumpers on the card to E1 and not left them on T1?
The jumpers are on E1 - the cables should be ok (they are working with
other hardware) - and the card is directly connected to a simens ULAF+
STU Desktop (can't really find much information about this device on the
net) - which turns off a red led when i load the driver and do a ztcfg.
> 
> I think the leds should turn green when the card senses a correct carrier
> and framing on the lines.
green is always a wounderful color ;-)

so, what else could cause this ?

wolfgang