[Asterisk-Users] Use 1 port of an E400P as IP connection

[Martin Pycko]

Configure the span 1 as
nethdlc=1-31

You have to have HDLC enabled in your kernel.
Then compile zaptel/sethdlc (in zaptel "make sethdlc")
and then
ztcfg -vv
sethdlc hdlc0 mode hdlc (or mode cisco)
ifconfig hdlc ip_address network network_address

that's it!
Now you have IP over HDLC/CISCO HDLC.

regards
Martin

On Thu, 20 Mar 2003, David Luyens wrote:

> Thanks Martin, could you point me into the direction on how to do this?
>
> David
>
> -----Original Message-----
> From: asterisk-users-admin at lists.digium.com
> [mailto:asterisk-users-admin at lists.digium.com] On Behalf Of Martin Pycko
> Sent: Thursday, March 20, 2003 7:10 PM
> To: asterisk-users at lists.digium.com
> Subject: Re: [Asterisk-Users] Use 1 port of an E400P as IP connection
>
>
> Sure. You configure it as HDLC or CISCO HDLC and you have
> hdlc0 interface to send data.
>
> regards
> Martin
>
> On Thu, 20 Mar 2003, David Luyens wrote:
>
> > Hi,
> >
> > I would like to use * as a compression box.
> > Between 2 sites I have an E1 leased line.
> >
> > So would it be possible to use 1 port of an E400P card to route my IP
> > IAX calls over in order to cut the ip router out of the picture?
> >
> > David
> >
> >
> > _______________________________________________
> > Asterisk-Users mailing list
> > Asterisk-Users at lists.digium.com
> > http://lists.digium.com/mailman/listinfo/asterisk-users
> >
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>