[Asterisk-Users] Setting up the E100P

[Michael Bielicki]

On Monday 23 June 2003 2:58 pm, Anton Yurchenko wrote:
> Hello,
>
> I have an E100P, and in the zaptel.conf I have:
>
> span=1,1,0,ccs,hdb4,crc4,yellow
> fxsks=1-10
delete the fxsks line and put:
bchan=1-15,17-31
dchan=16
>
> the light on the card is green( BTW what do all those states of the card
> that zttool reports YELLO, RED, BLUE ..., is there a doc for zttool?, or
> for the card?)
>
> in the asterisks` zapata.conf I have:
>
> [channels]
> context=default
> switchtype=euroisdn
> signalling=fxs_ks
> usecallerid=yes
> hidecallerid=no
> callwaiting=yes
> callwaitingcallerid=yes
> threewaycalling=yes
> transfer=yes
> cancallforward=yes
> callreturn=yes
> echocancel=yes
> echocancelwhenbridged=yes
> rxgain=0.0
> txgain=0.0
> group=1
> callgroup=1
> pickupgroup=1
>
> immediate=no
> callerid="line1"< 238-20-31>
> channel => 1
> callerid="line2"< 238-20-31>
> channel => 2
>
>
> but Asterisk on startup reports that:
>
> WARNING[13326]: File chan_zap.c, Line 4173 (ss_thread): CallerID returned
> with rror on channel 'Zap/1-1'
> WARNING[14351]: File chan_zap.c, Line 4173 (ss_thread): CallerID returned
> with rror on channel 'Zap/2-1'
>
>
> and when I call the number that is supposed to terminate there I get
> busy signal.
> also in the zttool  I see strange thing, in the bottom portion where
> there are RxA, RxB .... the 1111111 ( ones) sometimes change into
> 000000, they go from up to down and if I enable all the channels then
> firs on the first column then on the second column, in the bottom half
> of the screen.
>
> while if I plug the same E1 into Cisco AS5300, whit this config( just
> exepts):
>
> isdn switch-type primary-net5
>
> controller e1 ...
>  clock source line primary
>  pri-group timeslots 1-31
> ...
>
> interface Serial0:15
>  isdn switch-type primary-net5
>  isdn incoming-voice modem 64
>
> Framing is CRC4, Line Code is HDB3, Clock Source is Line ...
>
>
> on Cisco the swithtype is primary-net5 ( my guess its euroisdn ? )
>
> anybody could guess what is the problem?
>
> The admin that runs the Cisco says that signalyng should be PRI , and there
> is an option for pri signaling in zapata.conf, but the zaptel,conf doesnt
> have it and so I`d get up with a mismatch, and zasterisk would not start.