[asterisk-r2] No outgoing or incoming calls using Elastix 1.5.2. Perhaps a timing issue

[Gerardo Barajas]

Just to mention that, because of the customer requirements and pressure, I
made kind of "roll-back" using Elastix 1.3 and UNICALL and now everything
goes very well. Hope one day I can migrate to libopenr2.

Thanks everyone for the support.

gB

On Wed, Aug 5, 2009 at 6:22 PM, Gerardo Barajas
<gerardo.barajas at gmail.com>wrote:

> Just to confirm that there is not any E1 converter.
> As Carlos wrote, the NBX works behind an Encore converter. But anyway, the
> test were made wihtout the Encore. The NTU is connected to the Sangoma's
> A101 via a RAD Balun.
> I'll try with another Sangoma Card, and I'll tell ya.
>
> Regards.
>
>
> On Wed, Aug 5, 2009 at 1:17 PM, Gerardo Barajas <gerardo.barajas at gmail.com
> > wrote:
>
>> Carlos,
>> I'll check if the converter is disconnected from the E1 as soon as I can.
>> I'll keep you informed guys. Thanks a lot.
>>
>>
>>
>> On Wed, Aug 5, 2009 at 1:10 PM, Carlos Chavez <cursor at telecomabmex.com>wrote:
>>
>>>        Some 3Com NBX systems do not directly support R2 so they use an R2
>>> to
>>> ISDN converter on the line.  Are you sure the converter was disconnected
>>> from the E1?  I remember many 3Com providers complain about the delay
>>> the converter introduces when making and receiving calls.
>>>
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-r2/attachments/20090806/eea2c14a/attachment.htm