[asterisk-r2] No outgoing or incoming calls using Elastix 1.5.2. Perhaps a timing issue

[Gerardo Barajas]

 Just to confirm that there is not any E1 converter.
As Carlos wrote, the NBX works behind an Encore converter. But anyway, the
test were made wihtout the Encore. The NTU is connected to the Sangoma's
A101 via a RAD Balun.
I'll try with another Sangoma Card, and I'll tell ya.

Regards.

On Wed, Aug 5, 2009 at 1:17 PM, Gerardo Barajas
<gerardo.barajas at gmail.com>wrote:

> Carlos,
> I'll check if the converter is disconnected from the E1 as soon as I can.
> I'll keep you informed guys. Thanks a lot.
>
>
>
> On Wed, Aug 5, 2009 at 1:10 PM, Carlos Chavez <cursor at telecomabmex.com>wrote:
>
>>        Some 3Com NBX systems do not directly support R2 so they use an R2
>> to
>> ISDN converter on the line.  Are you sure the converter was disconnected
>> from the E1?  I remember many 3Com providers complain about the delay
>> the converter introduces when making and receiving calls.
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-r2/attachments/20090805/8b485f0d/attachment.htm