[asterisk-users] Showing the name of the called number at the source IP Phone, how?

[bilal ghayyad]

The IP Phones that I am using is the Digium D40, but did not find any place to enable the RPID, I do not know if they are enabled by default.

Any advise?
Regards
Bilal

----------------------------------
 
> Hi,
> 
> You need to set rpid on the calling phone settings, if that
> phone knows
> what to do with RPID. Then you need to set allowrpid=yes in
> the sip peer
> settings of A party and B party. I did that on CISCO 79X0
> phones and it
> worked perfectly,
> 
> Regards,
> Sammy
> 
> 
> On Tue, Aug 7, 2012 at 3:43 AM, bilal ghayyad <bilmar_gh at yahoo.com>
> wrote:
> 
> > Hi All;
> >
> > Asterisk 1.8.11-cert1
> >
> > I need to do the following, how?
> >
> > If my extension is 500 and I need to call the extension
> 501, so when
> > dialing 501, then I need to be able to see the name of
> the 501 (for
> > example, the name was: Mike, so I need to see at my IP
> Phone that I am
> > calling Mike which is the name of the destination).
> >
> > How?
> >
> > Regards
> > Bilal